1 New Vibe Tech Model VTG-5024D Heated Cob Dryer

1 New Vibe Tech Model VTG-5024D Heated Cob Dryer

Contact us for price

Location:Little Rock, AR

orCall 1 501-897-1110

Description

DELIVERY: Call for current lead time F.O.B: Michigan TERMS: 50% deposit with order, balance due before ship WARRANTY: CLM Vibe Tech Inc. will warranty the above equipment against defects in workmanship and materials for a period of one year. Defective parts are to be either repaired or replaced at Seller’s discretion. FACTS & CONDITIONS: The above shipping date is an approximation. Also the weight is approximate due to the options the exact may vary. Seller assumes no responsibility for faulty installation, misuse of machinery and faulty advice of others not employed by the seller. Buyer is responsible for all costs of installation and use of machinery. Seller is not responsible for any federal, state or local regulations that apply to the customer nor cost of any damage the process might cause such as inhalation of chemicals, waste, noise damage or harm from improper use. OPTIONS Manual Gate allows for batch capabilities Dust Cover Dust Collector (must be combined with cover) On dryer applications a 6″ hole in the center of the cover is connected to the dust collector. This dust collector would be tied into the control panel and operated from the face of the panel. The dust collector is a bag design with 30 super strength dust bags, 1/2 HP motor 3 phase 400 cfm (@8″sp) and manual cleaning with shaker. Auto Grease System is tied into the panel and will supply both top and bottom bearings with a factory set amount of grease. SPECIFICATIONS AND CONDITION ARE CORRECT TO THE BEST OF OUR KNOWLEDGE AND ARE SUBJECT TO YOUR VERIFICATION AND CORRECTION.

Specifications

ModelVTG-5024D
ConditionNew
Capactiy7 cubic feet working capacity (depending on media)
Construction3/16" Outer Wall, 1/4" Center Wall, 1/2" Top and Bottom Bearing Mounting Plate
Bowl width52"
Machine height42"
Process channel width13"
Unload height34"
Horizontal profile1/3 Rise
Motor5 HP 230/460 Volt, 3 Phase, 60 Cycle
Bearing type2 Double Row Spherical Bearings with extra clearance for vibe application
Bearing assemblyCast Steel, piloted housing, flange bearing
Lubrication typeManual Grease
Parts load chuteIncluded
Separation typeFixed ramp standard (For one pass only)
Screen deck typeCoated or uncoated woven wire, machined UHMW or cast polyurethane
Screen deck designInternal Semi-extended screen (120 degree)
Electrical controls-NEMA control panel, 230/460/3/60, 115 volt control circuit. Panel has fused disconnect, overload protection, push button controls and total hour meter. Control panel is mounted on a fabricated frame to stand alone by the machine. Allen Bradley components are used in the panel.
Heat systemThe tub weldment is wrapped with a 600 degree heat resistant insulation then covered with a 14 ga outer skin. Six 1000 watt heater elements are mounted on the base with three of the elements on all the time the heat system is on. The second set of three elements cycle on and off as programmed. This is set by the operator and controlled by timed relays in the control panel. The system also has a cool down timer to protect the cob meal from scorching.
Eccentric weightsSlip on style weight segments and a moveable top master weight allow for easy adjustment.
PaintMill Ivory (Off White) Industrial grade enamel
Floor space5' x 5'
WeightApprox 1,800 lbs.